Phoenix has a maximum limit of 100 page tabs per plot display panel (i.e., display set). This is only a limit on the number displayed, all plots are created, and, if an export is requested, all plots are exported. If a dataset contains more than 100 profiles mapped to a lattice condition, then plots 101 to 200 are contained in the second display set, etc. The Plot Content tab provides controls for switching between display panels and for adjusting the number of tabs available at one time in a display panel.
Select Plot > Layout in the tree, then click the Content tab.
In the Display Set box, type or use the up and down arrows to switch to another set of page tabs (i.e., a different display set).
In the Pages per Set box, type or use the up and down arrows to adjust the number of plot page tabs per display set. (Maximum is 100.)
Press Force Redraw to apply any changes made to the settings on this tab.
Clicking in another field or pressing the Enter key after changing the value in a field also triggers a redraw.
The example below uses the default settings for the Content tab. The first 100 pages of the latticed results are available in Display Set 1.
The figure below shows that the third display set has been selected for display and that the number of pages per set has been lowered to 10. Pages 21 through 30 are available when Display Set 3 is selected.
