Additional_output

Additional output

Additional output consists of files that cannot be viewed within Phoenix but can be exported and viewed in other software. Additional output files remain part of a Phoenix project, but they cannot be used as input to any Phoenix object downstream. Often files created as additional output have the potential to be very large (e.g., simulation). When exporting and importing these files back into Phoenix, caution should be taken to ensure sufficient memory resources.

BootSubj(B).csv

Created for bootstrap mode run. Table showing the subjects that were randomly included in each sample as well as the numbers of tries for those samples.

dmp.txt

These files are created for population models with the Simple mode. The dmp.txt files can be loaded into R and used for processing of Phoenix NLME results in R. Individual eta shrinkage statistics are listed at the end of the file. See the Omega worksheet description for information on shrinkage computations.

Rawout.csv

These files list the estimates of Thetas, Omega, and Log-Likelihood for each executed sample.

Rawsimout.csv

These files list the simulation estimates for each executed sample. When running simulation in an individual model, one Rawsimout.csv file is generated for each subject.

Rawsimtbl01.csv–Rawsimtbl05.csv

Optional tables created by the Predictive Check mode, if Tables are requested under the Tables tab and the size is too large to load into Phoenix. The content depends on what is entered.

Additional Simulation output

Optionally, if a folder is selected in which to copy simulation results, then csv files are saved to that directory. This is only available for population models in Simulation run mode.

Predout.csv

The same as the PredCheckAll worksheet described above (see the “Worksheet output” section).

simtbl01.csv–simtbl05.csv

Optional tables created by the Simulation mode, if Add Sim Table is used on the Options tab. The content depends on what is entered.